Growing

Morning all,

Yesterday, I was home alone, which meant i actually scrapped two layouts,Today is dull and overcast although quite warm so decided to do my two posts  from yesterday first thing and then  I just have one more item to complete before the end of the month.

My First post is the second sketch for the month for "Lets get Sketch" blog.Yesterday i was going through my book that i list all my challenges in, ensuring i had completed all that  i wanted to do ( I nearly forgot about this one ), I had  not written it up in my book, but had printed it out and found it tucked at the back.
I chose to use an old Kaisercraft papers as there was only a little bit left and it suited the sketch as it did not require much paper. The paper I used was  "Technologic". all the bits left were scraps left over. I have written the instruction as if you had full sheets. I have made many cards from the collection as well as several layouts, but still those bits i hate to throw out.

http://letsgetsketchy.blogspot.com

MY INTERPRETATION :

PRODUCTS USED:

Kaisercraft card stock "Stone"

Kaisercraft  "Technologic" collection, :- Pixels reverse, Reboot, Abort Reverse, Gigabyte,  Gloss Specialty Sheet Delete Cogs  Salvage strip from Bar Code, Key board sticker sheet and ESC sticker sheet 

Kaisercraft Dye, Mini cogs

Rub on for "Technologic

2 x Photos 5" x 4"

CUTTING:

Cut "Pixels" reverse 8" x 6" (leaving salvage intact)

Cut Reboot 8.50" x 5.50"

Cut "Abort" 1.5" x 8.50"

Cut  "Delete Cogs" 1.50" x 8.50"

Cut "Delete Cogs"1.50" x 4"

Fussy Cut Robot from "Gigabyte"

Dye cut small cogs from "Reboot" and "Pixels" reverse

ASSEMBLY:

Added salvage from "from "Bar Code" to the top of "Stone" card stock

Underneath added stars from the sticker sheet

Added photos to Reboot leaving 0.25" gap

Added photo mat to "Pixels" reverse leaving 0.25" gap at left side and top

Added strip of Alphabet to the top of Pixels

Added "Deleted Cogs" 1.50" x 4" 1.75" from the left hand side and 1.25" from the top

Added "Abort" 1.75" from the top and 2.50" from the left

Added   "Delete Cogs" 1.50" x 8.50", 2.50" from the top and 3.25 from left hand side

Added "Pixels" 0.75 from left and 3.25 from top

Next is to the embellishments

Take your dye cut cogs and using a mixture of each colour place at the bottom left of your photo Adding an addition of a robot from the ESC sticker sheet  

Add title from  Key board sticker sheet 

Add a mixture of other elements from the  ESC sticker sheet

Add the robot cut from  "Gigabyte" to the far right of photo

Use the Rub on cogs to the top right of your photo

See photo of layout for placement of the embellishments